It is possible to configure multiple Seq instances on the same server, so long as they listen on different network endpoints. These might be unique hostnames, e.g.
http://qa.my-seq/ or virtual directories e.g.
Named instances are useful for non-critical environments and low-throughput scenarios. For production deployments, a single instance per server is recommended.
Creating a Named Instance
This guide will walk through the creation of a named instance that listens at virtual directory. This is a convenient option to use because it doesn't require modifying DNS entries, but the process for hostname-based instances is otherwise the same.
To avoid URL conflicts, when using virtual directories it's best to remove the default Seq instance using
seq uninstallbefore setting up named instances. This isn't necessary if the instances listen on different hostnames.
Named instances are installed, configured and managed by adding a
-n <name> switch on the command line. This will:
- Default the instance's storage path to a subfolder of C:\ProgramData\Seq\Instance
- Set up a unique Windows Service for the instance
Nearly all command line actions available through seq.exe accept the
-n parameter. Don't forget to specify it when starting and stopping the instance.
To install a Seq instance named QA, use the command-lines:
seq install -n QA -l http://yourserver/qa seq start -n QA
Seq will now be listening at
Add/Remove Programs not required
It's not necessary to run the Seq .msi installer for each instance - the installer should be run once only, and the command line used for instance creation.
For an instance named "Dev" on the same server:
seq install -n Dev -l http://yourserver/dev seq start -n Dev
Updated less than a minute ago