Viewing and changing the location of Seq's local data on disk.
Seq stores log data and configuration on the file system. The location it uses is called the storage path.
The default storage location is the folder
Seq under the Windows
ProgramData folder, which is generally hidden by Windows Explorer.
On most systems, the storage path will default to
Contents of the Storage Path
Seq uses several sub-folders to organize storage.
Under the storage path can be found:
AppData- apps that run hosted in the Seq process store their own files here
Documents- configuration data such as the list of users, queries, retention policies and so-on
Extents- events written to Seq, divided into seven-day blocks
Logs- Seq's own diagnostic logs (shared between all Seq instances)
Packages- NuGet packages containing binaries downloaded when apps are installed
Seq.config- the Seq configuration file
Changing the Storage Path
If you need to customize your Seq installation, you can do this using the
Seq.exe command-line app from an Administrative command prompt.
The reconfiguration process doesn't require any use of the Windows Add/Remove Programs applet; use the
Seq.execommand-line for the tasks described below.
To change the storage path:
- The service is stopped and uninstalled
- The data is moved, if required, and new folder permissions applied
- The service is reinstalled and started
Uninstalling the Service
Uninstalling the Seq service does not have any impact on the stored events or configuration - only the Windows service entry.
To uninstall the service, run:
seq stop seq uninstall
Wait for the service to stop cleanly before proceeding.
When an alternative storage location is required, the best approach is simply to move the entire
Seq folder and all its contents.
If the service is being run as an account other than the default Local System, make sure that account can access the new location.
Reinstalling the Service
Finally, the service is reinstalled with the new storage path specified.
seq install --storage="PATH/TO/STORAGE" seq start
If this fails, reach out to support - reconfiguration is a safe process, so it is likely that a few changes in command parameters will get you back up and running quickly.
Seq's own log files
Independent of the storage path specified, Seq writes its own troubleshooting logs to
C:\ProgramData\Seq\Logs. It is important that the Seq process has access to this folder.
To change the location that a Seq instance writes its internal logs to, set the
diagnostics.internalLogPathvalue in Seq.json.
Updated less than a minute ago